Can Double Cell Light Filtering Shades Be Restrung

February 16, 2022 Post a Comment

Introduction

It is important to know how to restring cellular shades due to wear and tear from house pets, small children, and accidental damage. This guide outlines an like shooting fish in a barrel repair for broken or worn strings that can be done at home instead of completely replacing the shade.

Unscrew the tassel and set aside.

Unscrew the tassel and set aside.
Using a flathead screwdriver, open the cord stop, remove from the strings, and gear up aside.

Close the shade and push up, sliding the shade out toward the center of the room.

Close the shade and push upwardly, sliding the shade out toward the centre of the room.
This is a common method for taking down a cellular shade just not all shades are hung the same style. Use the appropriate method for your shade.
Identify the shade on a flat surface to work on.

Measure and cutting the new nylon strings. To be safe, the length should exist equal to the sum of the window width and twice the window top. In that location will be excess cord and information technology volition be cut off in step 14.
Length = (Window Width) + 2*(Window Height)

Apply the flathead screwdriver to take the terminate caps off of the superlative rail and set aside.
Take out the spiral using the phillips screwdriver and slide the top rail off.
Using the needle nose pliers, push the cord lock clips in from the side and slide the cord lock out, removing the strings and setting the string lock aside.

Flip the shade over and pull the end caps off of the bottom rail. Set them aside.
Slide the bottom rail off and set aside.

Untie the ends of the strings betwixt the weights on the lesser of the shade.
Pull the strings out of the shade and discard.

Thread the new string through the restringing needle.
Pull the needle and thread through the shade, making sure to leave three inches out of the bottom side of the shade.
Repeat for the other strings.

Tie a knot with the three inch piece and pull the string tight.
Repeat for the other strings.

Slide the bottom rail back onto the shade.
Button the lesser end caps back onto the rail.

Plough the top runway over so that the meridian is on the piece of work surface.
Thread the strings through the small gap in the summit rail that the string lock was removed from.
The ends of the strings should be on the outer side of the top rail.

Restring the cord lock by beginning picking up the strings coming out of the cord lock gap. Thread them through the side opening of the cord lock and out of the dorsum opening.
Thread them back through the dorsum opening and out of the forepart opening. Make sure to pass the strings through the black rectangular slice inside the cord lock.
Pull the strings tight so that the strings are merely in the front and side openings.

Insert the cord lock into the gap in the pinnacle rail with the opaque plastic side facing up.
Lay the strings downwards the middle of the shade.
Slide the meridian rail onto the shade, pulling the strings tight through the cord lock.
The cease of the runway without the cord lock should exist slid on kickoff.

Utilize the phillips screwdriver to put the screw back into the top track.
Button the end caps back into identify.

Rehang the shade by pushing the shade up into the clips and sliding information technology towards the window.
This is a common method for rehanging cellular shades but not all shades are hung the same way. Use the appropriate method for your shade.
Open up the shade and cutting the strings so the ends are halfway up the shade.